ETC$ and C$ empty

[tchuise92]

hii excuse me i just started data ontap 7-mode and i have a problem when i try to access in my c$ and my etc$ from my domain controller it is empty i first thought that all the folders were hidden but i check the capacity of the folder and it is marked 0 byte thank you in advance for your help

[JGPSHNTAP]

You're vol0 security is probably unix

type 

qtree status vol0

[tchuise92]

i just checked and it is ntfs

[JGPSHNTAP]

Then you have permissions.. What's the share level permissions and then you need to check NTFS rights

[tchuise92]

about the permission i have the full control(rwx) on the share o both C$ et etc$

[rwelshman]

Can you check the CIFS shares on the filer to see where c$ and etc$ are pointing?

[tchuise92]

i don t know where they are pointing but to reach the C$ its / and the etc it is/etc like i the image below

[rwelshman]

Ok, it should be pointing to vol0, can you do a "vol status vol0" "df -g vol0" "qtree status vol0"?

[tchuise92]

i dont understand when you say it should be pointing to vol0 how can i make it point to vol0?? i did the 3 commands you asked me to do what is it for??really thank you for your understanding 

[rwelshman]

You might want to increase the size of vol0, this is where the Data OnTap operating system files are kept. The C$ and etc$ shares will open to directories on this volume.

The used space looks really low, what version of Data OnTap are you running?

[tchuise92]

hi i increased the space available in the vol0 but it is still an empty folder i am using data ontap 8.2.3 7-mode the simulator 

[tchuise92]

hi i increased the Vol0 space an it is still an empty folder  i am using data ontap 8.2.3 7-mode simulator