Question about changing disk setup

[shypervisor]

Simulate ONTAP® 9.7 Installation and Setup Guide describes the simulator limitations. (like 220 GB and its disk size max is 9GB).

Is there any official document to change these parameters?

It seems exist in various forum discussions.

Thanks in advance

[GidonMarcus · Accepted solution]

Short answer - no there isn't 😕

These are the most "official" ones you'll find:

https://community.netapp.com/t5/Developer-Network-Articles-and-Resources/Adding-disks-to-a-Data-ONTAP-8-1-1-Simulator/ta-p/86240

https://community.netapp.com/t5/Simulator-Discussions/ONTAP-Simulator-Fixes-MEGA-Thread/m-p/11213#M87

[shypervisor]

During this command "systemshell" does not exists. Is there additional operation required?

The command "set -privilege advanced" works fine. but "systemshell" command does not found even in help message.

[jcolonfzenpr]

I have pasted the below link for further information:

https://arkit.co.in/access-systemshell-node-shell-netapp-cluster-mode/

Hope this helps.