Sim 8.1x47 - Change Ser + Sys ID - PANIC

[mskubski]

Hello,

I try to setup a second Cluster-Mode Node. After I did the change procedure:

SIMLOADER> setenv SYS_SERIAL_NUM 4034389-06-2

SIMLOADER> setenv bootarg.nvram.sysid 4034389062

and boot, the System asks to overwrite the values ... ???

If I say yes or no, in both cases the System panics!

Any Idea?

Thank you

regards

Maurice

[AGUMADAVALLI]

Please follow the directions from the below link, you should be good to go.

https://communities.netapp.com/thread/23046

you should apply the system serials, boot parameters and initialize the boot or some thing like that in the menu. I will zero the disks and reboots.

thank you,

AK G

[mskubski]

This is exactly what i did... but then there is the panic. maybe i can screenshot it ...

[aborzenkov]

At which point? It has to be the very first action before simulator is booted even once. I never managed to recover after I changed sysid under initialized simulator.

[mskubski]

Please see here: