Simulator Discussions

Sim 8.1x47 - Change Ser + Sys ID - PANIC

mskubski
3,475 Views

Hello,

 

I try to setup a second Cluster-Mode Node. After I did the change procedure:

SIMLOADER> setenv SYS_SERIAL_NUM 4034389-06-2

SIMLOADER> setenv bootarg.nvram.sysid 4034389062

and boot, the System asks to overwrite the values ... ???

If I say yes or no, in both cases the System panics!

 

Any Idea?

 

Thank you

regards

Maurice

4 REPLIES 4

AGUMADAVALLI
3,475 Views

Please follow the directions from the below link, you should be good to go.

https://communities.netapp.com/thread/23046

you should apply the system serials, boot parameters and initialize the boot or some thing like that in the menu. I will zero the disks and reboots.

thank you,

AK G

mskubski
3,475 Views

This is exactly what i did... but then there is the panic. maybe i can screenshot it ...

aborzenkov
3,475 Views

At which point? It has to be the very first action before simulator is booted even once. I never managed to recover after I changed sysid under initialized simulator.

mskubski
3,475 Views

Please see here:

Public