VMware Solutions Discussions

Problem with luns/volumes

EMPOWERISM
4,878 Views

I created volumes/luns in Netapp E2600 and connectes the Netapp to a host with a SAS cable,

The problem is when I create volumes in Netapp I can not see them in the ESX server without rebooting the server or remove the cable and connect it again!

I realy need your help ,Any solutions??????

6 REPLIES 6

radek_kubka
4,879 Views

Okay, did you rescan the HBA on the ESX host?

Normally this is the operation used for discovering new LUNs presented to a host.

EMPOWERISM
4,879 Views

Yes I rescaned it but there is nothing after rescan ,only I can see them after rebooting or remove the cables?!!!!!

Just for some information ,I am using esx 5.5 and LSI HBA .

rwelshman
4,878 Views

Which version of ESX are you running? How many hosts are connected? Do you have a LUN with ID 0 in the list?

EMPOWERISM
4,879 Views

I am using esx 5.5 and I connect 3 hosts to it but when it was only 1 host at the begining it was like now.

Yes ,I have a LUN with ID0.

rwelshman
4,879 Views

What happens when you perform a rescan on the HBA - does it complete successfully? When you look in the storage adapters section on the ESX hosts, the number of visible LUNs doesn't change?

EMPOWERISM
4,879 Views

Yes ,exactly.when I rescan, it completes successfully but no change in the Luns, only when I remove the cable and connect it again or reboot the host , I can see LUNs there.

Public